Title:
Aqua Air AA002 Model 230 Wet Dry Central Vacuum $4,414.80
Description
Free Shipping.
We can figure out everything you will need for your job if you give us your specs.
AQUA-AIR Wet/Dry Central Vacuum Power Units
Wall mounted central vacuum power units provide high volume dry vacuuming and quick drying wet extraction. Water rinse and cyclonic action separates the water, dirt, and debris without the restriction of filters. Waste tank automatically rinses and flushes all water and dirt down the drain. Central vacuum power units connect to multiple vacuum inlet/water outlet stations via water lines and vacuum tubing.
Aqua Air AA002 - Model 230 Central Vacuum Unit & Wet Extractor with 2 Motors
- Single Canister (14" x 47")
- Two 5.7" Extractor Motors, 3 stage, epoxy coated sealed bearings
- Each motor rated at 137" Water Lift.
- 202 CFM
- 13.7 amp, each motor.
- 120 volts.
- Ideal for homes and light commercial up to 7,000 square feet.
RECOVERY TANK: The cyclonic separator and cold water spray separate the water, foam and debris from the air flow without restrictive filters or mechanical floats. Large debris is contained in a mesh screen while the liquids automatically dump down the drain.
UTILITY REQUIREMENTS:
ELECTRICAL: 120 volt, 60 hertz, 15 amp standard plug.
WATER: Cold water with shut-off. Hot water (up to 170°F [77°C]) with shut-off. Connect directly to water outlets or to optional cleaning solution injector (AA031 or AA033).
DRAIN: 2" DWV drain to sewer. A p-trap will be required and vent to meet plumbing codes.
EXHAUST: If power unit is located in a small room, exhaust air from the vacuum motor must be exhausted to the outside of the building using the most direct route possible.
INSTALLATION:
POWER UNIT: Locate in an area where it will be protected from freezing. The mounting bracket should be firmly attached to a wall stud or masonry wall. A minimum space of 12" is required from the ceiling and on each side of the unit. The unit must be mounted high enough above the floor as to allow for drain connection and easy access to service the debris screen.
Vacuum inlets are conveniently located near doorways, in hallways or other centrally located areas. The vacuum lines are regular 2" PVC vacuum tubing and fittings.
WATER OUTLETS: Water Outlets are located next to the vacuum inlets. (In existing structures where access is limited the outlets may be located under sinks or on other wall where access is possible. The water lines may be either 3/8" or 1/2" PEX, 3/8" copper or other equivalent tubing appropriate for the building with connections made in accessible areas.
COMMERCIAL LIMITED WARRANTY: The manufacturer warrants to the initial purchaser that the AQUA-AIR Wet/Dry° power unit and cleaning solution injector will be free from defects in material and workmanship for one (1) year from the date of the first consumer purchase or one thousand (1000) hours whichever occur first, and that hoses, tools and other attachments will be free from defects in material and workmanship for ninety (90) days from the date of the first purchase.
Aqua Air YouTube Videos.
Free Shipping from Contractors Store. 239-357-1853 Craig.
Designed and assembled in the USA.
For shipping to Alaska, Hawaii & Canada call for pricing.
Payment can be made over the phone via Visa, MasterCard, American Express or Discover by calling 239-357-1853 Craig.